PDA

View Full Version : Width of aluminium X and Y profile on PRS Alpha's?



ozchimp
03-07-2010, 03:33 PM
Hi,

Does anyone know the width of the aluminium tslot profile used for X and Y axis on PRS alpha's?

Thanks in advance,

osc

Gary Campbell
03-07-2010, 04:52 PM
Bosch Rexroth has drawings of the extrusions on their website
Gary

ozchimp
03-08-2010, 06:08 AM
Gary,

Thanks, you're right but they have a large selection and I wanted to make sure I knew which to look at - thats why I asked for the widths?

osc

Gary Campbell
03-08-2010, 12:17 PM
osc...
Are you looking for the width of the extrusion or the width of the T slot? The Y beam is a 200 by 400 and the X rails are 75 by 300, I think.
Gary

ozchimp
03-09-2010, 04:37 AM
Gary,

Wow they are big and I don't think I've seen extrusions in those dimensions. I assume mm unit given the sizes?

75x300 is larger than the old PRT steel channel (C6x8.2).

Is the Y extrusion end face cross section really 200x400mm?

From the look of the assemblys I've seen I figured X were 40x160 and Y 160x80 or 200x80.

osc

Gary Campbell
03-11-2010, 09:40 PM
osc...
You are correct. The X are 40 by 160. The Y is 100 by 200. Must have had a brainfart on the conversion.

nat_wheatley
03-12-2010, 06:36 PM
Keep at it Gary, you'll learn to love it! :)