Shop bot buddy 32

[cwfreitas]

I have a Buddy 32 and the x & y stopped moving and I can only move the z axis up and down. It was working and stopped in the middle of a carve. any suggestions?

[bleeth]

Shut down SB software and control box and leave it down for 15 seconds or so and restart. If that doesn't work do it again but include a computer restart. Sounds like your drivers turned off for some reason.

[myxpykalix]

I would follow Dave's suggestions one step further and go to your circuit breaker box and turn off power completely to the control box because the box stores certain settings in it's memory and this would dump all memory and let you start over fresh.