estes53
02-09-2013, 11:09 PM
Am planning to buy a Shopbot Desktop to make 6"X10" plates for embossing leather, for shoes, in a 7 ton or 15 ton press.
Understand that the optimum material, steel, can't be cut on that machine, but am hoping that someone has enough experience to advise.
My ideas are polymer sheet for the initial run and then if it turns out to be a popular one do it on copper or brass so it will last longer.
Thanx in advance,
Alan
Understand that the optimum material, steel, can't be cut on that machine, but am hoping that someone has enough experience to advise.
My ideas are polymer sheet for the initial run and then if it turns out to be a popular one do it on copper or brass so it will last longer.
Thanx in advance,
Alan