Installing Gadgets in Aspire 4

[Bob Eustace]

Had the extra ones in 3.5 but for the life of me cant remember how to install them. The Help file doesnt tell you either? Looked in all the folders in Aspire but cant see where they go. Any help greatly appreciated. Want to stick some decorative spirals on a job due at the end of the week! There is now a spiral wrap but I just want the simple flat guy.

[Brian Moran]

Hi Bob,

The gadgets from 3.5 wont work with 4.0 as we have changed a lot of the interface. We have overhauled the location and installation of Gadgets and will be documenting the procedures from gadgets.vectric.com when they are ready.

For the time being (if you need it this week) I would suggest creating your spiral in 3.5 with your existing gadget and exporting the vector to 4.0.

Brian

[Simops]

Hi Brian.....bought Aspire 3.5 earlier this year......was I supposed to get an email to show how to upgrade to 4 then followed up with the CD set ? I haven't received any emails on how to upgrade and the support section at Vectric still talks about Ver 3.5.

Cheers

[Bob Eustace]

Hi Bob,

The gadgets from 3.5 wont work with 4.0 as we have changed a lot of the interface. We have overhauled the location and installation of Gadgets and will be documenting the procedures from gadgets.vectric.com when they are ready.

For the time being (if you need it this week) I would suggest creating your spiral in 3.5 with your existing gadget and exporting the vector to 4.0.

Brian

Thanks Brian - that worked just fine.

[adrianm]

Hi Brian.....bought Aspire 3.5 earlier this year......was I supposed to get an email to show how to upgrade to 4 then followed up with the CD set ? I haven't received any emails on how to upgrade and the support section at Vectric still talks about Ver 3.5.

Cheers

http://www.vectric.com/forum/viewtopic.php?f=27&t=16681

[Simops]

Thanks Adrian....Seems I have been overlooked as an email should have been sent out by March 4 .... I have emailed Vectric.

Cheers