View Full Version : recently updated software
twelchPTM
06-19-2013, 01:37 PM
I recently updated Partworks, SB3, the control box firmware, and I keep getting these weird glitches, I typed in JH and the SB# software initiated an automatic toolchange! I stopped it, typed JH again and it Jogged home. Also I stopped a partfile and the machine decided it was going to jog the Z axis to 72"!!
jerry_stanek
06-19-2013, 04:58 PM
try reinstalling it and see if that helps
ssflyer
06-19-2013, 05:32 PM
Did you follow the exact steps for installing the new firmware? If not, it will fail the install without an error...
twelchPTM
06-20-2013, 06:39 PM
followed everything exactly, reinstalled also. Todays neat little trick is pausing mid movement to take a break for about 3 seconds and then starting again!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.