jsfrost
09-02-2007, 07:13 PM
The install manual has a few holes, and I have questions:
I got heavier springs from SB as part of my upgrade, but the spindle still drops to the table. Should I be using both old and new springs?
The HSD spindle has an attached aluminum plate, but my bolts bottom out. There is literature suggesting an adaptor. Is this a separtate part I should have?
For the present, I have made what looks like a satisfactory attachment using a 5 washer stack to shorten my bolts. Any reashn why that should not work for the short term.
This was a two part upgrade, and the other half, new X and Y motors really improved the cut. Can't wait to evaluate the entire package. Maybe tomorrow.
I got heavier springs from SB as part of my upgrade, but the spindle still drops to the table. Should I be using both old and new springs?
The HSD spindle has an attached aluminum plate, but my bolts bottom out. There is literature suggesting an adaptor. Is this a separtate part I should have?
For the present, I have made what looks like a satisfactory attachment using a 5 washer stack to shorten my bolts. Any reashn why that should not work for the short term.
This was a two part upgrade, and the other half, new X and Y motors really improved the cut. Can't wait to evaluate the entire package. Maybe tomorrow.