Jerome
07-31-2013, 11:02 AM
I have been having some random problems with the spindle shutting down. Last night it would shut down every time I tried to run the spindle warmup routine.
I finally gave up and this morning I called shopbot.
He said it was noise from electrical interference. The computer was plugged into a power strip so I plugged it in to an unused outlet.
It worked. I guess the plug in strip was bad and caused enough static to cause the spindle to shut down.
I didn't get a his name but he was very helpful. Thank You again
Jerome
I finally gave up and this morning I called shopbot.
He said it was noise from electrical interference. The computer was plugged into a power strip so I plugged it in to an unused outlet.
It worked. I guess the plug in strip was bad and caused enough static to cause the spindle to shut down.
I didn't get a his name but he was very helpful. Thank You again
Jerome