View Full Version : Table sides
steve
02-25-2008, 05:04 PM
OK it's here , started putting the table together to day. I have a 12"Z , so two sets of sides , my question is , should the two sides , one sitting on top of the other , be connected? They are both fastened at the ends of course , the lower side has the cross beams attached and the top side has only the X-rails to resist any flex. Seems to me they should be connected. Maybe I missed something?
Stephen
steve4460
02-25-2008, 10:28 PM
Hi Stephen
There is 2 plates with 8 holes in them that get put in the middle of the 2 aluminum extrutions
Check your manual or go here http://www.shopbottools.com/files/docs/SBG00324070823SplicePlateInstall.pdf
Good luck and happy botting
Stephan
steve
02-25-2008, 10:44 PM
Thanks Stephan , that information is not in my manual.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.