Hoytbasses
10-21-2013, 10:21 AM
Happy Monday:
everything was working fine on friday. This morning we set up a job , checked the Z axis w/o problems.
when I go to zero the x,y axis the x hits against the left side and wants to continue to advance. (past 0 on the display.) It doesn't stop at 0.....
I shut off the bot and rebooted the Shopbot 3 program, but to no avail
usually a warning message about moving the bot off the stop switch comes up but not today.
how do I reset it to correctly zero the x,y axis?
thanks
Karl
everything was working fine on friday. This morning we set up a job , checked the Z axis w/o problems.
when I go to zero the x,y axis the x hits against the left side and wants to continue to advance. (past 0 on the display.) It doesn't stop at 0.....
I shut off the bot and rebooted the Shopbot 3 program, but to no avail
usually a warning message about moving the bot off the stop switch comes up but not today.
how do I reset it to correctly zero the x,y axis?
thanks
Karl