Probe to dxf to Aspire model

[pyrodenis]

I read the 2012 post on this, but thought I should just start a fresh thread.
I probed and used Probe to Surface, in order to have data to import. However, the model size is different than the scan size. For instance, I scanned x_2", y_4.5", to a maxZ_-5.5
The highest point in the scan was -1.309"; so, I would expect a model size of x_2,y_4.5,4.191. BUT, I am looking at a model size of 2,4, 4.088
Anyone?

[Brady Watson]

Where did you set your Zzero? How deep did you tell it to probe? You didn't probe the table surface did you?

Did you scan (raster) in the X or Y direction?

You scanned as an SBP, and then converted it to a 3D DXF, correct?

-B

[pyrodenis]

I've managed to get the files to create components.
I set Zzero at .02" above the object. I did not scan the table. Object is 7.25" thick. There were numerous 'cliffs' around the edges at different hieghts. So, i used differents maxZ plunges to avoid trouble.
Now, looking at what I did, I'm thinking, "what a mess!"
Now, I have to make a way to create components inside, as I want to take .5 to 1" off the surface. This is the bottom of the "bowl".
I've attached an image of the components.... my mess.

[Brady Watson]

Ha! You are right...that IS a mess! BUT - a great opportunity to hone your skills in Aspire.

If you sent it out to be laser scanned, you'd be cutting right now! :D

-B