Trupan MDF in Brooklyn NY ?

[german]

HI GUYS, ANY IDEAS WHERE TO FIND TRUPAN IN BROOKLYN OR NY CITY AREA, I'M TRYING TO FINISH MY TABLE AND THIS IS HOLDING ME BACK.
JUST ONE PLACE SELLS THE ULTRALIGHT KIND.
THANKS IN ADVANCE FOR ANY HELP.
GERMAN.

[wberminio]

German
Chesler Ply in LI 718-343-1700
Rosenzweig Lumber in the Bronx 718-585-8050
Roberts ply in LI 631-586-7700
Conn. Ply

Start with these companies,there are others

Erminio

[german]

THANK YOU VERY MUCH ERMINIO, I WILL TRY NEXT MONDAY.
GERMAN.

[Brady Watson]

http://www.atlanticplywood.com/

-B

[german]

Brady, that is the place i was talking about in my first post, they just have ultralight for sale, i know i cant use this kind for my plenum board; is that correct?
thank you guys for your advice.
german

[Brady Watson]

Ultralight is the ONLY kind that you want to use. Nothing yeilds better performance. If you cannot get it, then regular is OK as well as MDF ultralight, but at a performance hit.

-B

[btk]

I buy from Chesler in New Hyde Park.
They are the only ones that have actual Trupan.
Roberts has lightweight MDF and Atlantic does not have Trupan (they have lightweight)

Chesler has tons of it in every size.

Brian

[wberminio]

That's where I get my Trupan.

Where are you located Brian?

Erminio

[ed_lang]

I buy my Ultralight Turpan from Atlantic Ply in Richmond, Va. It is the same company up the East coast.

[wberminio]

Not all Branches carry the same materials.You need to check a branch locally.I haven't dealt with Atlantic for years,so I'm not sure what they carry
in NYC area.

[german]

you guys are right, atlantic does not have any at all, but otherwise chesler does have like BTK and ERMINIO said, tomorrow i'm going to make a trip to long island to get a couple of sheets.
thaks for all the inputs, i appreciate it.
german

[btk]

@Erminio I am located in Queens, NY.

@Ed Lang good point, I meant to say that the two Atlantic Plywoods located here on Long Island do not stock "Trupan".

Brian

[wberminio]

Brian
I'm in Westchester Co. just north of you

[ed_lang]

Atlantic can get anything from another location in a week. My location may be out of something and they tell me that it will be on the transfer truck and to them in a week or less.

They deliver to my shop, I don't go driving around looking for materials.

Sounds like the Richmond branch gives better service than the others.

[wberminio]

The companies I suggested all deliver on a regular basis.Sometimes, if your in a bind or only need a few sheets(not enough for delivery), its good to know where you can pick up material close by.
You're right Ed,I always try to have my materials-plywood/hardware- delivered to my shop,
It saves time-
Time =$$$$$