View Full Version : Will a Donek drag knife work with the Desktop?
wespor
12-09-2013, 11:18 AM
I'm worried about the z height, I'd need to fit in a vaccum table, leather and the bit which looks pretty long from the photos. Has anyone had success using one on this little machine?
scottp55
12-09-2013, 11:38 AM
http://www.talkshopbot.com/forum/showthread.php?t=18143&highlight=desktop
wespor
12-09-2013, 11:48 AM
Ohhhh, that's one gorgeous setup. Thanks.
wespor
12-09-2013, 11:59 AM
Looking at that more though, it's still nerve rackingly close to the knife, assuming it's sitting at the full height. I wonder if you can further shrink the height of the air chamber without affecting the airflow.
scottp55
12-09-2013, 01:01 PM
http://www.talkshopbot.com/forum/showthread.php?t=14959
scottp55
12-09-2013, 01:04 PM
http://www.talkshopbot.com/forum/showthread.php?t=17841
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.