larry_high
02-02-2014, 08:38 AM
I have been using the MTC post processor and have had very good results until yesterday. it seen that there are limitations to how you number the tools in the data base. have searched the manual and online and can't find any reference to what numbers are available when numbering tool tools. I do understand that 31 and 32 are part of the drill commands, but beyond that nothing.
how do you number your tools and what numbers are used and can symbols or letters be used to identify tools.
Oh the problem that occurred when using the MTC was when it switched to a tool number 21 it changed the Z axis to A axis in the VI.
Thanks
Larry
how do you number your tools and what numbers are used and can symbols or letters be used to identify tools.
Oh the problem that occurred when using the MTC was when it switched to a tool number 21 it changed the Z axis to A axis in the VI.
Thanks
Larry