View Full Version : Will you be attending
sc.crab
02-02-2014, 09:55 AM
Aspire at Mcgrew's 2014.
It will be nice to meet and put a face with all of you.
Ajcoholic
02-02-2014, 02:14 PM
Yes! I look forward to going back to school... :)
sc.crab
02-02-2014, 03:41 PM
Look forward to meeting you.
Ajcoholic
03-02-2014, 04:23 PM
Is it just us two attending from here?? Pretty quiet...
I am booking my flights this week (I have to fly from Timmins, to Toronto, to Washington, to SC - so it's a bit of a haul for me) but I am looking forward to it, a lot.
sc.crab
03-02-2014, 04:29 PM
Is it just us two attending from here?? Pretty quiet...
I am booking my flights this week (I have to fly from Timmins, to Toronto, to Washington, to SC - so it's a bit of a haul for me) but I am looking forward to it, a lot.
I guess I'm lucky I have a 10 mile drive.
sc.crab
03-02-2014, 04:34 PM
We might be the only ones representing the blue machines. Last year it was almost all camasters that I met.
Ajcoholic
03-02-2014, 05:16 PM
We might be the only ones representing the blue machines. Last year it was almost all camasters that I met.
OK, no prob. I am going for the Aspire info/training anyhow...
And to see what a 21,000 sq foot shop looks like ;) I have 6,000 and I thought that was a fair size. :)
sc.crab
03-02-2014, 05:48 PM
Look forward to meeting you.
mtylerfl
03-02-2014, 06:05 PM
We might be the only ones representing the blue machines. Last year it was almost all camasters that I met.
I will be there and Tim Merrill will too. We both use (and love) the blue machines!!
Simops
03-02-2014, 11:23 PM
I'd love to come......but 18 hours in economy doesn't turn me on:p
Unfortunately I cannot make it this year. Had a great time last year, lots of show and tell, Jim puts on a nice event, Vectric always has a great presentation. If you can make it, it is a great opportunity to talk with fellow CNC folks...
Mark Farris
03-03-2014, 11:42 AM
I'll be there again this year helping to represent the blue machines. Really enjoyed it last year.
Mark
mtylerfl
03-04-2014, 10:47 AM
Unfortunately I cannot make it this year. Had a great time last year, lots of show and tell, Jim puts on a nice event, Vectric always has a great presentation. If you can make it, it is a great opportunity to talk with fellow CNC folks...
We'll miss you TJ! Besides that, who is going to take me somewhere for a big plate of Hot Wings now?!
sc.crab
03-04-2014, 11:32 AM
I think he has a good excuse this year.
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.