Puzzle Project - Start to Finish

[TJ]

Please join me this Wednesday February 12th at 1:00pm EST

For this training we will import a vector, then use the Vectric software to cut this vector into slices that we can make into a puzzle. This will start with a design and follow the project through until it is cut and finished. Areas of interest will include tolerances, bit change, hold down, nesting and the exposure to a project from start to finish.

Here is what the project will look like:
http://www.shopbottools.com/Training/Videos/pf1.jpg
http://www.shopbottools.com/Training/Videos/pf2.jpg
http://www.shopbottools.com/Training/Videos/pf3.jpg

I will record and post this training. Hope to see you there. TJ

1. Please join my meeting.
https://global.gotomeeting.com/join/467767221

2. Use your microphone and speakers (VoIP) - a headset is recommended. Or, call in using your telephone.

Dial +1 (646) 982-0003
Access Code: 467-767-221
Audio PIN: Shown after joining the meeting

Meeting ID: 467-767-221

[TJ]

http://www.shopbottools.com/Training/Videos/PuzzleFaceTraining.wmv

OR

http://youtu.be/X1Qz7_v2gMY

Whichever works best for your browser.. Enjoy

[scottp55]

Thanks TJ, New antivirus program blocked go to meeting and gave up after 45minutes or I would have thrown my laptop across the room:) Hope it went well.