November/December 2012 Issue

[myxpykalix]

Does anyone have the November/December 2012 Issue of Woodworkers Journal?

I'm looking for the included files they have for the making of a longworth chuck and where they recommend buying the bumpers and other parts.

[myxpykalix]

nevermind...i found them...haven't found the source for the bumpers but haven't finished reading....:D

I think i asked about this previously....:eek:

[Burkhardt]

Not sure what the magazine recommended but I used these (mounted upside-down) for a similar purpose:

http://www.mcmaster.com/#9540k933/=qtjwml

http://images2.mcmaster.com/Contents/gfx/large/9540k27p1l.png

They have a reinforcing washer molded-in to avoid the screw pulling through. Not expensive at 70 cents each.
I would have preferred white ones but as long as the work piece does not slip the rubber does not leave a mark.