PDA

View Full Version : motorcycle club plaque



Brian Harnett
02-28-2014, 06:24 AM
A lot of this was done on the bot all the 2d work I then textured and did the 3d work with my die grinders, the bit in the Makita is a solid carbide bit made for cutting fiberglass, they are great in wood and last along time, they are like drawing with a pencil.

The wood was milled with my alaskan chainsaw mill.


http://i.imgur.com/pMnH2HN.jpg

http://i.imgur.com/dPpW5wb.jpg

http://i.imgur.com/Vymk7do.jpg

http://i.imgur.com/GoGqzWK.jpg

bobmoore
02-28-2014, 08:24 AM
Looks real good Brian. What kind of wood and how thick did you make it?
Bob

Brian Harnett
02-28-2014, 08:40 AM
The wood is white pine its about 1 1/2 thick at the thickest point.

I put it in my kiln before it was machined. It will be inside so eliment damage will not be an issue.