Brian Harnett
02-28-2014, 10:46 AM
Two air cylinders run through the table on this setup to clamp the front and back of the drawers the end clamps I have had set up for years.
If I was to do a lot more I would have set up a stop for the sides for these I just leveled them up by feel.
The cylinders are controlled by solenoid valves activated on the switchboard
A short video
https://vimeo.com/87861666
http://i.imgur.com/qA2u8lQ.jpg
http://i.imgur.com/xfsUiJD.jpg
http://i.imgur.com/zB4sdxQ.jpg
If I was to do a lot more I would have set up a stop for the sides for these I just leveled them up by feel.
The cylinders are controlled by solenoid valves activated on the switchboard
A short video
https://vimeo.com/87861666
http://i.imgur.com/qA2u8lQ.jpg
http://i.imgur.com/xfsUiJD.jpg
http://i.imgur.com/zB4sdxQ.jpg