Doors

[Howley]

Looking at this door it was done with a V carve bit. However the outside corner is not rounded so of the bit must've been pulled up on the corners. Does anybody know how to do this using Vcarve Pro 7.5?

[Regnar]

Profile tool path "On" with Sharp Internal Corners check marked.

[gc3]

you need a offset vector to do that...

[gc3]

Profile tool path "On" with Sharp Internal Corners check marked.


suggest you double ck this option...you can see it's blanked out

there are other other programs for making doors as you are asking for

[steve_g]

Gene, et al…
This option works well with cuts inside or outside the line… but not “on” the line.
SG

[Regnar]

Everyone is correct. Sorry I was trying to use memory to answer the question and well its starting to slip from me. Here is what 2 profile passes will get you. By the looks from the photo he might be using a Vbit with a flat bottom rather than a point. His corners inside the pocket area still look rounded.

[gc3]

shows 3mm vector offset with sharp corner option

[myxpykalix]

gene....nice desktop wallpaper

[gc3]

gene....nice desktop wallpaper

thx jack!!

[gene]

A helper like that in the show would great for attendance , but would be a disaster for safety:D