Hobodog2
05-20-2014, 06:12 PM
I am running a PRT Alpha with 7.2 gearboxes.
I upgraded my control PC with a Win 8 PC and downloaded new control software and I upgraded the firmware.
Problem: Output #4 (stops the ShopBot) comes on when I set up the probe for a probe and the error message says that the probe must be contacting something (no) or the probe wiring is incorrect (no).
Actually, output #4 comes on without the probe being connected electrically as soon as I do the final steps on the probe setup and tell it to probe, I get the error message. Must be a configuration setting somewhere, but I can't figure which one.
Any ideas please?
I upgraded my control PC with a Win 8 PC and downloaded new control software and I upgraded the firmware.
Problem: Output #4 (stops the ShopBot) comes on when I set up the probe for a probe and the error message says that the probe must be contacting something (no) or the probe wiring is incorrect (no).
Actually, output #4 comes on without the probe being connected electrically as soon as I do the final steps on the probe setup and tell it to probe, I get the error message. Must be a configuration setting somewhere, but I can't figure which one.
Any ideas please?