Initial Sound, LLC
06-02-2014, 01:34 PM
Hello I just started looking for a G202 Driver.
My Z stopped moving. Noticed the software was sending a command, the Z was moving on screen. Checked Z driver and light wasn't on. Switched Z and B Driver, Z worked perfect. B "Bad Driver". The led remained off on the Bad G202 Driver.
Pictures:
https://www.dropbox.com/sh/7dt9yw3xkwmcroe/AACRUgBfMpH5jfmQjjVFWkcca
Anyone have a Gecko G202? Suggestion?
Should I change out the electrolytic capacitor or some other component? Has anyone had success servicing these units?
Extreme delta t is a factor in this situation. I had cold (-20 F; 0 F) ambient operating temps this last season.
Should I somehow use a G203 and build an digital invert circuit?
Any help would be appreciated.
Thanks!
My Z stopped moving. Noticed the software was sending a command, the Z was moving on screen. Checked Z driver and light wasn't on. Switched Z and B Driver, Z worked perfect. B "Bad Driver". The led remained off on the Bad G202 Driver.
Pictures:
https://www.dropbox.com/sh/7dt9yw3xkwmcroe/AACRUgBfMpH5jfmQjjVFWkcca
Anyone have a Gecko G202? Suggestion?
Should I change out the electrolytic capacitor or some other component? Has anyone had success servicing these units?
Extreme delta t is a factor in this situation. I had cold (-20 F; 0 F) ambient operating temps this last season.
Should I somehow use a G203 and build an digital invert circuit?
Any help would be appreciated.
Thanks!