spindle speeds

[ronperusi]

I have a prs Standard I bought new in 2010 The spindle always changed speeds to what I had in the tool data base automatic. Now when I run a C5 the spindle changes speeds automatic, but when I run a file the spindle just stays at 14,000 rpm and doesn't change to the different speeds I have for different tools. Hope I explained this right.

[jhedlund58]

Make sure you are using proper post processor. I have had similar problems. For me, I first clean out my USB ports. Blow out with air and re-seat. I usually re-boot the control machine. After that, if the spindle warm-up routine works all is fine.

Hope this helps, to me the new control software works fine. Most of my problems are prevented by general maintenance.

[ronperusi]

Thanks for you help, I had the wrong post processor