Rounded edge

[mkcfl]

Is there a way to do something similar to a 2 rail sweep in PartWorks 3.5? I am trying to make a 1x3 ft. rectangular part that has to have a specific rounded edge. I can set it up in Aspire, but I only have the trial version that does not let you cut the file.

[steve_g]

MK
Some of the Guys do amazing things with tapers and flutes ,but since you said “A specific rounded edge” I’d say not likely done in V-carve… Sometimes I forget I have other tools besides my CNC router… If the specific edge is a common shaped router bit you can finish the profile on a router table…
SG