dscdragon
08-24-2014, 08:04 PM
Just installed an indexer on my desktop.
Was able to run a rounding tool path and everything seemed to work ok.
Tried to then run a spiraling tool path. It seemed to make the first spiral fine. When it traversed in the x axis back to start over for the second pass. It jittered and lost its place.
I slowed all of the move and jog speeds and tried it again. Same issue. Definatley seems to drive to fast. Any suggestions where to look to fix this?
Was able to run a rounding tool path and everything seemed to work ok.
Tried to then run a spiraling tool path. It seemed to make the first spiral fine. When it traversed in the x axis back to start over for the second pass. It jittered and lost its place.
I slowed all of the move and jog speeds and tried it again. Same issue. Definatley seems to drive to fast. Any suggestions where to look to fix this?