Panel #6 Gates of Paradise

[terryjones]

Let me start out by giving some history of this panel from the door at the Baptistry of St. John in Florance, Italy.

http://www.digital-images.net/Gallery/Scenic/Florence/Duomo/Baptistry/baptistry.html#Gates-ofParadise

This is Cypress measuring approx. 8" x 8" x .5"
Started out with .25 endmill to get rid of some of the bulk.
The finishing was completed with .0625 ballnose with a 10% step over at .83 IPS.

[POPS 64]

Very nice work , excellent piece. Jeff :)

[terryjones]

Thank you, really appreciate it.

[khaos]

Really great piece. What bits did you use?

[genek]

Extremely Nice. Did you do the design. If you did the design extremely talented.

[elcar903]

very nice work

[terryjones]

Hey Joe,
Thanks for the comment. This is what I used.
Started out with .25 endmill to get rid of some of the bulk.
The finishing was completed with .0625 ballnose with a 10% step over at .83 IPS.

Terry

[terryjones]

Good evening Eugene,
I purchased the model as this really intrigued me with the detail. I want to run it again, but the next time bigger. The original on the door of the baptistry is 31.5" x 31.5". I want to gold leaf the finish on this to match the original.

Thanks again,
Terry

[genek]

Good evening Eugene,
I purchased the model as this really intrigued me with the detail. I want to run it again, but the next time bigger. The original on the door of the baptistry is 31.5" x 31.5". I want to gold leaf the finish on this to match the original.


Thanks again,
Terry
where did you purchase it... I have a Catholic church in my area that was destroyed by a tornado a few years back and they have almost finished the new building, would like to offer to do their doors for them,

[terryjones]

Eugene,
Here is the link from where I purchased this model.
http://www.3dmodelclub.com/cmsj15/models/all-stock-models/stock-models-by-category?page=shop.browse

Terry