PDA

View Full Version : Vacuum table



bob_dodd
10-01-2014, 04:28 PM
I made a vacuum table for the DT for cutting stencils with Donek drag knife , It is mounted on top of the wedge table and held in place with cap screws and inserts in bottom board (Scott P's idea) . a shop vac inlet is from under side out in front , a grid on 1" centers was cut and a PVC cover with 1/4" holes on 1" centers , works well for use with drag knife . Has anybody else made one for the DT ? if so some pictures please

donek
10-01-2014, 08:18 PM
The guys at make magazine made one so they could cut leather.
http://makezine.com/magazine/behind-the-build-vacuum-table-2/