Andrew Kreutter
12-29-2014, 09:59 PM
We build our doors 1/16" oversized. We currently run them through a shaper to trim them to size. We end up with a number of problems with door size and out of square. I am thinking I want to cut them to size with the bot. I am thinking I want to take 1/64 per pass with a clime cut to avoid chip out on corners? What is the best way to program this on the fly so a operator could just enter the size without the need to draw and tool path each door size? All our cabinets are a inset door and this is why we need the perfectly square and correct size.