Xray
04-17-2015, 05:48 PM
Had this for a couple weeks and finally got around to putting it to the test.
Impressive, I think they should be in everyones bit arsenal. Easy setup, I just put the paper on a .25 mdf square I had laying around and taped the paper to it, no need to even screw down the board.
Of course if I did this alot I would rig up something better, but my point is at its root it is very simple to use using materials at hand with any profile toolpath.
[You can see on the 2nd pic I had some dragging issues, probably need to set Z to retract a little higher, I had it at only .10 to save time, .15 I bet would cure that problem] Or, perhaps the paper was rising at that one point, really didn't have it secured very good.
I got this one here from a fellow CNC'er
http://cosmos-industrial.com/index.php? ... ex&cPath=3
Well worth the small investment, opens up another area of creativity.
Impressive, I think they should be in everyones bit arsenal. Easy setup, I just put the paper on a .25 mdf square I had laying around and taped the paper to it, no need to even screw down the board.
Of course if I did this alot I would rig up something better, but my point is at its root it is very simple to use using materials at hand with any profile toolpath.
[You can see on the 2nd pic I had some dragging issues, probably need to set Z to retract a little higher, I had it at only .10 to save time, .15 I bet would cure that problem] Or, perhaps the paper was rising at that one point, really didn't have it secured very good.
I got this one here from a fellow CNC'er
http://cosmos-industrial.com/index.php? ... ex&cPath=3
Well worth the small investment, opens up another area of creativity.