PDA

View Full Version : spindle help! 2.2 HP standard SB


ArtFilmgroup
04-20-2015, 07:27 PM
I just install the new 48 x 96 SB standard with spindle and i can't get the spindle work
-already connect the computer,
-tested motors and moved all directions

But i can get the spindle work i checked the light in output in control yellow, and i tried to warm up for the window and nothing.
power light in the spindle box its blinking
thanks
I need some directions
Brady Watson
04-20-2015, 07:58 PM
Did you put the key in the control box & turn it on? It's the one on the end of the wrench.

-B
ArtFilmgroup
04-20-2015, 07:59 PM
Yes, i did, and nothing
ArtFilmgroup
04-20-2015, 08:09 PM
i am guessing the thin cable from VFD black/white its wrong connected in my book say (E-Stop) and i did connected in that place . might be wrong.
Brady Watson
04-21-2015, 06:17 AM
i am guessing the thin cable from VFD black/white its wrong connected in my book say (E-Stop) and i did connected in that place . might be wrong.

Yeah...that's not right. Black & white to the VFD terminals on the control board. Re-read the assembly manual part about wiring it up.

-B