Brady Watson
10-27-2015, 02:07 PM
Every once in a while I scan something whimsical for me or a family member. In this case, a flower...
They gray ones are different than the orange one (different flower). These are 75mm, 150mm and 400mm tall. The original was around 175mm tall from the end of the stem to the open bell of the flower.
These could be machined in wood with some thoughtful effort. I didn't feel like doing all of that & there would be places that the bit couldn't even get to because of undercut folds etc. You'd need 5 axis to fully resolve every portion if you didn't want any hand work. 3D printing - no problem. :cool:
-B
They gray ones are different than the orange one (different flower). These are 75mm, 150mm and 400mm tall. The original was around 175mm tall from the end of the stem to the open bell of the flower.
These could be machined in wood with some thoughtful effort. I didn't feel like doing all of that & there would be places that the bit couldn't even get to because of undercut folds etc. You'd need 5 axis to fully resolve every portion if you didn't want any hand work. 3D printing - no problem. :cool:
-B