k4mg
08-28-2009, 01:43 PM
I needed to shift my ShopBot PC over to a different CNC machine, because I wanted to use a faster PC on the ShopBot. I installed the latest SB software (same version as the old PC) onto the new machine, and copied over from the old PC my shopbot.ini file from the sb3 folder, and the whole SbParts folder from the C: location.
The ShopBot moves OK, but if I try to home with a C3, I get the message to move off the limit switches, and no matter where I move, it never clears. If I plug back into the old machine, everything works fine.
What have I for gotten to move?
Or any other suggestions?
Thanks, Barry
The ShopBot moves OK, but if I try to home with a C3, I get the message to move off the limit switches, and no matter where I move, it never clears. If I plug back into the old machine, everything works fine.
What have I for gotten to move?
Or any other suggestions?
Thanks, Barry