View Full Version : Rough Start point?
angelosart
01-06-2016, 02:53 PM
Is there a way of changing the starting point on a rough cut? I have a rough cutting toolpath that starts at 23,0 and moves along the Y axis. I want to be able to start at 0,0 and move along the Y axis.
Thanks
Kyle Stapleton
01-06-2016, 03:28 PM
Yes, it is in material setup in your toolpath tab2698326984
angelosart
01-06-2016, 04:37 PM
Hi Kyle,
I might not have explained myself correctly. I want the rough cut to go from left to right along the x axis not right to left. I tried changing the datum point but that didn't work either.
Angelo
Tim Lucas
01-06-2016, 05:02 PM
Just a single line?
angelosart
01-07-2016, 09:49 AM
Hi Tim,
The entire cutting file. It rasters along the x axis. It starts on the far end of the x axis and works toward 0. I would like it to start from 0 and raster along the x axis toward the far end.
Thanks
Angelo
Tim Lucas
01-07-2016, 08:01 PM
without seeing what your tool paths look like its hard to guide you - can you post any of it?
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.