PDA

View Full Version : Desktop y axis



gobblerthreat
03-05-2016, 11:25 PM
First post here, hope your bots are running great!

My desktop jams a lot at any point along the y axis. I am cutting mostly solid surface materials and losing a lot of it trying to figure all of this out. Speed & ramps do not seem to matter as it has been changed from slower to normal values many times. The linear rails do not seem to be a factor . I think it's jamming underneath. Do you have any suggestions for me. I appreciate any likely answer because I can use all of them to try for resolve.

Thank you,

Jeff

scottp55
03-06-2016, 07:43 AM
Welcome Jeff,
Have you seen this thread and run through some usual suspects?
http://www.talkshopbot.com/forum/showthread.php?22594-Rough-movement-in-the-x-y-and-z-axis
scott

Kyle Stapleton
03-06-2016, 08:54 AM
Does it move the full range with the key pad?

gobblerthreat
03-06-2016, 01:48 PM
Hi Scott, I will check that thread. Thank you!

gobblerthreat
03-06-2016, 01:50 PM
Hi Kyle, once it is freed up its fine but, as, I run a file its not minutes and then it jams anywhere along the axis.

Thanks!