View Full Version : How I screwed up a cut and how I fixed my screw-up
phil_o
03-28-2016, 08:53 AM
I would like to thank Joe Crumley, his response in a previous post helped me out. Read the attached link to see how Joe helped.
http://forum.vectric.com/viewtopic.php?f=2&t=24593
Phil
dmidkiff
03-29-2016, 08:33 AM
Good save.
knight_toolworks
03-29-2016, 11:20 AM
ya sign foam is scary though caring is where I screw up the least. when doing expensive stuff I do a lot of checks I use a pen to draw the sign onto the foam so I can check placement. I do a air cut I check the simulation on the machine zero the bit then drop it down and check the hight to make sure it is right.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.