Keefe1
03-31-2016, 03:53 PM
My shop lease is up and this has initiated a decision to change direction in business and let go of this fine but woefully underutilized machine.
I purchased it 3 years ago from a machinist in NC who himself bought it after it's brief time as a demo model at Shopbot and never even set it up.
I'd imagine is has less than 75 hours on it.
I've run warm-up routines, and just a handful of cuts.
I had big plans for it, but work has taken me in other directions.
2.2 HSD Spindle (220V single phase). Comes with a relatively new set of (Chinese) collets, the 7-piece solid carbide "starter set" from Centurion Tools, and I'll include the relatively new control PC and router with Partworks software.
I will dis-assemble and crate/palletize, but buyer must handle shipping or pickup.
Asking $18k
27708
I purchased it 3 years ago from a machinist in NC who himself bought it after it's brief time as a demo model at Shopbot and never even set it up.
I'd imagine is has less than 75 hours on it.
I've run warm-up routines, and just a handful of cuts.
I had big plans for it, but work has taken me in other directions.
2.2 HSD Spindle (220V single phase). Comes with a relatively new set of (Chinese) collets, the 7-piece solid carbide "starter set" from Centurion Tools, and I'll include the relatively new control PC and router with Partworks software.
I will dis-assemble and crate/palletize, but buyer must handle shipping or pickup.
Asking $18k
27708