marcrunner
05-10-2016, 04:46 PM
http://www.talkshopbot.com/forum/attachment.php?attachmentid=28187&stc=1
Wondering how you guys would go about cutting this aluminum mold. I am confident with the straight end mill cuts, but when it comes to the round over, I wasn't sure what to use. These molds are roughly 36" in length. Would you just run a ball nose cutter on a 3d toolpath for this part?
Thanks,
Marc
Wondering how you guys would go about cutting this aluminum mold. I am confident with the straight end mill cuts, but when it comes to the round over, I wasn't sure what to use. These molds are roughly 36" in length. Would you just run a ball nose cutter on a 3d toolpath for this part?
Thanks,
Marc