Swing

[xtreme872]

Any one ever cut the parts for a porch swing on ShopBot? I am wanting to make one out of HDPE and figure it would be easier to cut parts out of a sheet? plus could pre drill

[bryan]

Does this count?
All parts the were curved or mortised were cut on the Shopbot.
But I used red oak for the whole project a few years ago.


http://www.talkshopbot.com/forum/attachment.php?attachmentid=28781&stc=1http://www.talkshopbot.com/forum/attachment.php?attachmentid=28782&stc=1

[xtreme872]

That's nice. My was curious if anyone already had any plans?


Does this count?
All parts the were curved or mortised were cut on the Shopbot.
But I used red oak for the whole project a few years ago.


http://www.talkshopbot.com/forum/attachment.php?attachmentid=28781&stc=1http://www.talkshopbot.com/forum/attachment.php?attachmentid=28782&stc=1

[bryan]

Thanks

If I remember correctly this bench plans were in a older woodworking magazine, which one not sure with out looking though several hundred I have in the office.

I just looked at the original files in my ArtCam projects, and see that I only cut the back curve and the mortises in the back with my bot, everything else was on the table saw or band saw.

Bryan