View Full Version : Z xero plate install
Tom Bachman
09-29-2016, 10:59 PM
I notice on my 'new' bot that there is a Z-zero plate, but it is not hooked up. My question is; How do I hook the wiring up to the board? I still need to trace out the wiring harness but, need to get things hooked up.
barrowj
09-30-2016, 05:11 AM
Tom,
(White or Green) goes to ground and Black goes to #1 and if you have Red, it goes to #5 on your wiring block in the control box. Hope this helps, here is a link to the Docs section: http://shopbottools.com/ShopBotDocs/gantry.htm
Joe
Tom Bachman
09-30-2016, 09:57 AM
Thanks Joe, I'll trace out the wires and see if I can get them hooked up.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.