tlempicke
11-07-2016, 06:03 PM
I really liked the cutting board Joe Coholic designed and posted. So I swiped the idea! Built a jig, bought the lumber, glued it up and was about 2 minutes from finishing the first one when I took these pictures.
30 Seconds later we had a power glitch. This resulted in my Y axis loosing about 400 steps and crashing my brand new cutting bit through the right side wall of the board.
Pride Goeth Before The Fall!
So now my bride has a cut down version of the board and I will try again tomorrow.
At any rate, thanks for a great idea Joe.
http://www.talkshopbot.com/forum/attachment.php?attachmentid=29264&stc=1http://www.talkshopbot.com/forum/attachment.php?attachmentid=29265&stc=1
30 Seconds later we had a power glitch. This resulted in my Y axis loosing about 400 steps and crashing my brand new cutting bit through the right side wall of the board.
Pride Goeth Before The Fall!
So now my bride has a cut down version of the board and I will try again tomorrow.
At any rate, thanks for a great idea Joe.
http://www.talkshopbot.com/forum/attachment.php?attachmentid=29264&stc=1http://www.talkshopbot.com/forum/attachment.php?attachmentid=29265&stc=1