sluggo
12-26-2016, 04:03 AM
Good Morning All,
I'm not sure this is the right place for this post, but the maintenance section seemed appropriate.
I've attached a YouTube link of a short video showing what happens when I zero my x/y axes on my PRS Standard ShopBot. As you can see, the initial movement to the stop on each axis is smooth, but when it backs up and repeats the process at the slower speed, the carriage rattles. It's done this since day one and I always thought it was normal, but someone at the Vectric User Group Meeting in Orlando in October 2016 says it isn't. Any thoughts?
Charlie
https://www.youtube.com/watch?v=DffCgKoFE80
I'm not sure this is the right place for this post, but the maintenance section seemed appropriate.
I've attached a YouTube link of a short video showing what happens when I zero my x/y axes on my PRS Standard ShopBot. As you can see, the initial movement to the stop on each axis is smooth, but when it backs up and repeats the process at the slower speed, the carriage rattles. It's done this since day one and I always thought it was normal, but someone at the Vectric User Group Meeting in Orlando in October 2016 says it isn't. Any thoughts?
Charlie
https://www.youtube.com/watch?v=DffCgKoFE80