TJ
01-23-2017, 09:46 AM
Hello everyone,
Please join ShopBot Tools this Wednesday January 25, 2017 for a free online training. The topic this week is “Inlays.” The training begins at 1:00pm eastern time and runs approximately 45 minutes. It is then followed up by a 45 minute Q & A for participates to ask questions and work with each other.
Using a ShopBot and the Vectric software this training will demonstrate how to successfully inlay two different types of material. Areas covered will include compensation for bit radius, proper tolerances, machine setup and efficient toolpathing steps.
There is no need to sign up, just show up a few minutes early on Wednesday and click on the link below. You will log into GoToMeetings and wait for the training to get started. Make sure your computer volume is turned on.
If you have any other questions please feel free to shoot me an Email. This training will be recorded and posted for future viewings. Those recordings can be found on our ShopBot Tools Training Page.
Thanks and hope to see you there. Thanks, TJ
Inlay Training
Wed, Jan 25, 2017 1:00 PM - 3:00 PM EST
Please join my meeting from your computer, tablet or smartphone.
https://global.gotomeeting.com/join/749907373
You can also dial in using your phone.
United States: +1 (669) 224-3212
Access Code: 749-907-373
First GoToMeeting? Try a test session: http://help.citrix.com/getready
Please join ShopBot Tools this Wednesday January 25, 2017 for a free online training. The topic this week is “Inlays.” The training begins at 1:00pm eastern time and runs approximately 45 minutes. It is then followed up by a 45 minute Q & A for participates to ask questions and work with each other.
Using a ShopBot and the Vectric software this training will demonstrate how to successfully inlay two different types of material. Areas covered will include compensation for bit radius, proper tolerances, machine setup and efficient toolpathing steps.
There is no need to sign up, just show up a few minutes early on Wednesday and click on the link below. You will log into GoToMeetings and wait for the training to get started. Make sure your computer volume is turned on.
If you have any other questions please feel free to shoot me an Email. This training will be recorded and posted for future viewings. Those recordings can be found on our ShopBot Tools Training Page.
Thanks and hope to see you there. Thanks, TJ
Inlay Training
Wed, Jan 25, 2017 1:00 PM - 3:00 PM EST
Please join my meeting from your computer, tablet or smartphone.
https://global.gotomeeting.com/join/749907373
You can also dial in using your phone.
United States: +1 (669) 224-3212
Access Code: 749-907-373
First GoToMeeting? Try a test session: http://help.citrix.com/getready