Online Training Wednesday March 22nd, 2017 - Engraving/Cutting Acrylic

[TJ]

Hello everyone,

Please join ShopBot Tools this Wednesday March 22nd, 2017 for a free online training. The topic this week is “Engraving/Cutting Acrylic.” The training begins at 1:00pm eastern time and runs approximately 45 minutes. It is then followed up by a 45 minute Q & A for participates to ask questions and work with each other.

Using a ShopBot and the Vectric software this training will demonstrate how to successfully engrave acrylic. Areas covered will include bit selection, feeds/speeds, toolpathing, types of material and cutting through the acrylic.

There is no need to sign up, just show up a few minutes early on Wednesday and click on the link below. You will log into GoToMeetings and wait for the training to get started. Make sure your computer volume is turned on.

If you have any other questions please feel free to shoot me an Email. This training will be recorded and posted for future viewings. Those recordings can be found on our ShopBot Tools Training Page.

Thanks and hope to see you there. Thanks, TJ

Engraving/Cutting Acrylic
Wed, Mar 22, 2017 1:00 PM - 3:00 PM EDT

Please join my meeting from your computer, tablet or smartphone.
https://global.gotomeeting.com/join/343194141

You can also dial in using your phone.
United States: +1 (571) 317-3112

Access Code: 343-194-141

First GoToMeeting? Try a test session: http://help.citrix.com/getready

[TJ]

Thank you everyone today for your turnout and your participation. We had a good session, good discussion, great Q & A's......... See you next time.

Here is the link to the training and please Email me if you would like a copy of the PowerPoint: https://youtu.be/p-lj5q7xy1Y

[Bob Eustace]

Thank you everyone today for your turnout and your participation. We had a good session, good discussion, great Q & A's......... See you next time.

Here is the link to the training and please Email me if you would like a copy of the PowerPoint: https://youtu.be/p-lj5q7xy1Y

Absolutely brilliant tutorial and a subject others seem to have completely missed! Maybe you could think about adding a bit on Dibond and Alucabond? Anyway great work TJ - you're worth more money!

Bob