rainbowboats@hotmail.com
06-12-2001, 09:32 AM
Hi folks
I am new so please bare with me. I have laid out a set of panels on a 4x8 sheet of plywood. Done all the conversions and laid out the cuts with vector. When I bring the file into shopbot the diagram looks good but the left hand side is way out over the edge and is too far up as well. Is there a way to bring that back into the "BOX"?
Thanks
Eric
I am new so please bare with me. I have laid out a set of panels on a 4x8 sheet of plywood. Done all the conversions and laid out the cuts with vector. When I bring the file into shopbot the diagram looks good but the left hand side is way out over the edge and is too far up as well. Is there a way to bring that back into the "BOX"?
Thanks
Eric