PDA

View Full Version : SB Shows Axis Is Moving... But CNC Is Not



Nstep007
06-30-2017, 08:17 PM
Little history, My usb control card went bad. Got a new one in the mail today. Now when I go to "move" It shows in the software the basic is moving... But the CNC is not moving at all. I have downloaded the firmware, made sure the drivers were up to date, done all I know to do. Any other suggestions ?

Gary Campbell
06-30-2017, 08:47 PM
All are not moving? Check the power supply to the drivers

Nstep007
07-01-2017, 12:59 AM
Its all good. when I attached the usb control card to the main card, I did not re attach the main card to the drivers assuming i would have to tear into it.... replaced like it should be, restart... and boom....