Bob1144
08-29-2017, 05:18 PM
Shop bot controller with 4 Geckos 201 drivers
usb cable to computer 47 volt ps
4 pk299-01aa steppers with good pinions, ( 1" 20 deg pa)
all wires for motors
p4 2.4 ghz computer with win xp loaded with shop bot 3 control
software and part wizard
everything worked great when I took them off.
could run 600 ipm ( not much torque) but could do it for fast traverse.
typically ran 200 to 300 ipm cutting
will send the software that came with it, the original manual, and a laptop that was also used to run it before I used the tower computer.
All the electronics are there for a complete working machine.
$1200
Thanks,
Bob
usb cable to computer 47 volt ps
4 pk299-01aa steppers with good pinions, ( 1" 20 deg pa)
all wires for motors
p4 2.4 ghz computer with win xp loaded with shop bot 3 control
software and part wizard
everything worked great when I took them off.
could run 600 ipm ( not much torque) but could do it for fast traverse.
typically ran 200 to 300 ipm cutting
will send the software that came with it, the original manual, and a laptop that was also used to run it before I used the tower computer.
All the electronics are there for a complete working machine.
$1200
Thanks,
Bob