View Full Version : Zeroing x and y
jerry_stanek
02-28-2009, 07:50 PM
I tried to zero my x,y with the c3 command and the x zeros fine but the y will not zero it hits the stop and just tries to keep going. The proximity stops work when I run the machine.
bernott
02-28-2009, 08:46 PM
Stupid Question... but is the Y prox adjusted to trip the system when it comes near the bolthead? & have you tried to trip it out manually (drive it over with the keyboard)?
jerry_stanek
03-01-2009, 07:26 AM
When I drive it over the bolt it trips and stops or I can trip it manually anywhere along the y with a piece of metal.
bernott
03-02-2009, 09:38 PM
I would try resetting your shopbot.ini file and go through the set up again, sounds like the file is bad & double check your values for the pox switches.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.