TJ
10-09-2017, 08:39 AM
Hello everyone,
Please join ShopBot Tools this Wednesday October 11th, 2017 for a free online training. The topic this week is “One Board Project: Coaster Set.” The training begins at 1:00pm eastern time and runs approximately 45 minutes. It is then followed up by a 45 minute Q & A for participates to ask questions and work with each other.
Using a ShopBot and the Vectric software this training will work through the creation of a coaster set from one board. This project may seem simple at first but it will cover the use of layers, setting up start depths and using the fluting toolpath. Other areas covered will include mid file bit changes, tolerances and tab sizes. It will be an action packed training and we hope you can join us.
There is no need to sign up, just show up a few minutes early on Wednesday and click on the link below. You will log into GoToMeetings and wait for the training to get started. Make sure your computer volume is turned on.
If you have any other questions please feel free to shoot me an Email. This training will be recorded and posted for future viewings. Those recordings can be found on our ShopBot Tools Training Page.
Thanks and hope to see you there. Thanks, TJ
One Board Project: Coaster Set
Wed, Oct 11, 2017 1:00 PM - 3:00 PM EDT
Please join my meeting from your computer, tablet or smartphone.
https://global.gotomeeting.com/join/502538973
You can also dial in using your phone.
United States: +1 (646) 749-3122
Access Code: 502-538-973
Joining from a video-conferencing room or system?
Dial: 67.217.95.2##502538973
Cisco devices: 502538973@67.217.95.2
First GoToMeeting? Let's do a quick system check:
https://link.gotomeeting.com/system-check
Please join ShopBot Tools this Wednesday October 11th, 2017 for a free online training. The topic this week is “One Board Project: Coaster Set.” The training begins at 1:00pm eastern time and runs approximately 45 minutes. It is then followed up by a 45 minute Q & A for participates to ask questions and work with each other.
Using a ShopBot and the Vectric software this training will work through the creation of a coaster set from one board. This project may seem simple at first but it will cover the use of layers, setting up start depths and using the fluting toolpath. Other areas covered will include mid file bit changes, tolerances and tab sizes. It will be an action packed training and we hope you can join us.
There is no need to sign up, just show up a few minutes early on Wednesday and click on the link below. You will log into GoToMeetings and wait for the training to get started. Make sure your computer volume is turned on.
If you have any other questions please feel free to shoot me an Email. This training will be recorded and posted for future viewings. Those recordings can be found on our ShopBot Tools Training Page.
Thanks and hope to see you there. Thanks, TJ
One Board Project: Coaster Set
Wed, Oct 11, 2017 1:00 PM - 3:00 PM EDT
Please join my meeting from your computer, tablet or smartphone.
https://global.gotomeeting.com/join/502538973
You can also dial in using your phone.
United States: +1 (646) 749-3122
Access Code: 502-538-973
Joining from a video-conferencing room or system?
Dial: 67.217.95.2##502538973
Cisco devices: 502538973@67.217.95.2
First GoToMeeting? Let's do a quick system check:
https://link.gotomeeting.com/system-check