Raised pin for jig

[Wilboy64]

How do I get the raised pin in the center of the jig ? Pocketing cuts it out. It is 1.0625 in diameter and .375 high. I tried selecting profile with a .5 but to get it this far and added extra circle vectors to run the tool on center to clean up . Is there a better way?

[srwtlc]

Not quite sure what you are looking to do, but if you select both an outer and inner circle and then pocket....?

[Wilboy64]

30900

Being new to the cnc world I wondered if there is a way to make the profile cut from the center circle vector to the outside vector with one profile cut path ?

[robtown]

http://www.talkshopbot.com/forum/attachment.php?attachmentid=30900&stc=1

Being new to the cnc world I wondered if there is a way to make the profile cut from the center circle vector to the outside vector with one profile cut path ?
Select both circle vectors and then do an Area Clear (or pocket) operation.