Fein Vac

[jerry_stanek]

Does anyone know where I can pick up brushes for a Fein Vac. I just had to free them up on one of mine

[Brady Watson]

If this part (https://www.ereplacementparts.com/carbon-brushes-two-p-1851545.html?osCsid=9fccben2oji7fqnf2t0dhldke0) (assuming Turbo III/9-77-25) is no longer available, any decent electric motor repair place should be able to make you a set.

-B

[knight_toolworks]

worst case you can replace the motor for about 150.00

[jerry_stanek]

I had a bunch of different brushes and found some that were the same. Changed them out and now it runs like new.

[fredtoo]

Old topic but hopefully you remember how the brushes came out?

[fredtoo]

Disregard the above message. The brush assembly I had tried was being troublesome. When I tried the other it came out as expected realizing a bigger 'hammer' was required for the first one. Problem solved.