Buddy grinds aginst home after software upgrade

[toddho]

I have a buddy (2010) and after upgrading to the latest software (and firmware) when I try a C3 to home with the prox switches it acts like it dose not see the switches and grinds staging the axis. I can see the prox switch inputs toggle when tested.

Any ideas on where to look?

Thanks
Todd

[Brady Watson]

Before you do anything else...Run the UI command and install the firmware. It MUST match the front end version of SB3.

Put your tool @ 0,0 (drive it there with a v-bit chucked in as a pointer) - ZX and ZY. Then run SB setup via the TS command. Follow the instructions. Be sure to click the 'I'm Done!' button at the end.

Now your C3 should work as intended.

-B